Question 1

How much does it cost to repair an electrical outlet?

Accepted Answer

Electrical outlet repair from Aardvark Electric is priced per job after on-site diagnosis, with upfront written pricing and a free quote. The biggest cost drivers are whether the outlet can be repaired or must be replaced (standard vs GFCI) and if any wiring or box issues are found during troubleshooting. Final pricing is confirmed after we test the circuit and verify code compliance, especially in areas that require GFCI protection near water. Our licensed electricians regularly price outlet repairs across the Brookhaven area and can explain repair-versus-replacement options on site. What typically changes the price: - Standard outlet swap vs GFCI upgrade for kitchens, baths, garages, or outdoors - Wiring condition, damaged device boxes, or heat/sparking evidence - Number of outlets or switches addressed during the same visit - Access limits (tight boxes, marked-up walls) and troubleshooting time Shut off the breaker and avoid using any outlet that smells, feels warm, sparks, or trips repeatedly until it’s inspected by a professional.
Updated: 2026-02-12
Need help in Brookhaven, GA? Call (404) 947-6851 or book online.

Question 2

Can I install a GFCI outlet myself safely and correctly?

Accepted Answer

Installing a GFCI outlet should be done by a licensed professional because GFCI outlet wiring is different and must be installed correctly to work. The most common issues after DIY installs come from miswired line/load connections that prevent the device from providing protection where water is present. GFCI stands for ground-fault circuit interrupter; it monitors current and cuts power if electricity starts going where it shouldn’t. These devices are required or recommended in bathrooms, kitchens, garages, outdoors, crawl spaces, and unfinished basements. Our licensed team handles code checks and inspections and regularly retrofits older homes to current safety standards across the Atlanta area, including Brookhaven. Call a pro promptly if you notice any of the following during or after an outlet project: - Frequent GFCI trips after a proper reset - Warm or visibly sparking outlets or switches - Buzzing from the device or box - Odors that resemble burnt plastic Turn off the breaker and avoid DIY on live circuits until a licensed electrician verifies correct GFCI wiring.
Updated: 2026-02-12
Need help in Brookhaven, GA? Call (404) 947-6851 or book online.

Question 3

Can I change a light switch myself without hiring an electrician?

Accepted Answer

Yes, a homeowner can replace a basic light switch, but Aardvark Electric recommends using a licensed electrician because miswiring can cause shocks, arcing, or code issues. The most common problems happen when switches share circuits or when the switch type (like dimmers, 3‑way, or smart controls) is wired differently than expected. We stress safety and code compliance, and our team handles these tasks daily with proper testing and labeling. Our electricians frequently bring older homes up to modern standards without drywall damage that DIY work can create. We provide this service across the Atlanta metro area with upfront, written pricing. Call a professional if you notice any of the following: * Strange odors, warmth, or visible sparking at the switch * Buzzing sounds, flickering lights, or GFCIs that trip often * Broken switches, loose outlets, or upgrades involving GFCI/AFCI or smart controls If you proceed, shut off the correct breaker and verify power is off with a tester before touching any wiring.
Updated: 2026-04-02
Need help in Atlanta, GA? Call (404) 947-6851 or book online. "He also looked through the house for any hazards, and confirmed all bathroom and garage outlets were properly GFCI protected." — Alfred W.

Frequently Asked Questions About Electrical

Outlet, Switch and GFCI Installation and Repair

Still Have Questions?